19
1.8 Install Memory/ Add-on module
1. Please make sure power plug had been removed.
2. There're tabs which located in the side of SODIMM holder.
Detach the existing memory from the memory slot.
3. Put the memory module with correct direction.
Notice there's one key position to make sure direction is correct.
4. Plug in memory module into SODIMM slot with angle 20 ~ 30°.
Make sure memory module plug into slot completely.
5. Using nger to push memory module vertically until the tabs lock memory module tightly.
Now, the memory modules have been plugged in properly with horizontal at.
6. Once installation done, please screw memory door back, and put the slide cover on proper
location.
7. Now, please plug power back and turn units on.
8. Any problem, please contact with local agency.
To Next Page
Loading...
