AOR AR2000 - Memory Channel Management; Entering and Storing Memories; Recalling and Clearing Stored Memories

AR2000 Operating manual Page 7
Memory mode
The receiver has 1000 memory channels arranged in 10 banks of 100 memories. The banks are
numbered 0 to 9.
1. It is possible to ENTER both frequency and mode into MEMORY.
(Memory BANKS start at 0 and continue through I, 2, to 9. Memory CHANNELS start at 00 and
continue through 01, 02, to 99).
MANUAL PROG (memory bank and channel) ENTER
Example: To enter the displayed frequency into MEMORY BANK 1, CHANNEL 52.
MANUAL - PROG - 52 - ENTER
Again, there is no need to press enter but there is no negative effect should you do so.
2. To enter a new frequency and mode into memory.
MANUAL (frequency in MHz) ENTER (mode) PROG (memory bank and channel number}
Example: To enter 145.600 MHz, FM mode into MEMORY BANK 0 and CHANNEL 55.
MANUAL - 145.6 - ENTER - FM - PROG - 055
N.B. Remember the displayed frequency can sometimes be automatically written into the current
memory channel when the mode is changed. Make sure you don’t accidentally over write a wanted
memory channel in this manner.
3. To RECALL the contents of a previously stored memory channel.
It is worth noting that frequencies are often already stored in the receivers memory bank when you
unpack it, this is part of the testing conducted during manufacturer and preparation for sale.
MANUAL BANK (bank and channel number)
Example: To recall the contents of memory BANK 1, CHANNEL 52.
(Remember, you must have something stored first).
MANUAL - BANK - 152
4. To CLEAR the contents of a previously stored memory channel.
MANUAL CLEAR ENTER PROG (memory bank and channel)
Example: To clear the memory contents of BANK 1, CHANNEL 20
MANUAL - CLEAR - ENTER - PROG - 120
©1991 AOR Ltd.