ANAN-G2 Manual Page 13 of 35
A connection for a balanced
microphone input is available.
This uses a 6.3mm jack on the
radio, and a cable can be made
to connect to an XLR socket.
If you have a balanced microphone terminating in an XLR plug, you will need to make a cable to an
XLR socket. Wire pin 1 to Ground, pin 2 to Mic+ and pin 3 to Mic-
Dig In
(two digital
inputs)
CW Key: if connected to
ground, this will key the TX
when in a CW mode
TX Disable: when connected to
ground, this will signal to your
SDR client app to request TX
disable. (In Thetis, this input
has to be enabled in the Setup -
> TX menu).
To Next Page
Loading...