ANAN-G2 Manual Page 28 of 35
6 Specifications
General Specifications:
• Architecture: Direct Sampling DDC/DUC Transceiver
• Interface: PCI-Express to Raspberry Pi; Ethernet from Raspberry Pi
• Phase Noise (Clock): -149dB @ 10Khz
• TCXO Stability (Typical): /- .1 PPM
• Modes: CW, SSB, NFM, AM, Digital
• Antenna Ports: Three BNC 50 ohms Software Configurable Ports, Three BNC ADC1 Bypass and
Loop in ports, One BNC for RX2
• Frequency Resolution: 1 Hz
Electrical Specifications:
• 13.8v DC @ 25A, 3A Receive/25A Transmit
Mechanical Specifications:
• 5Kg (approx. Weight)
• Dimensions: 365mm (L) x 310mm (W) x 140mm (H) (Not including extrusions)
• Rugged Aluminium Extrusion with internal fan.
Receiver Specifications:
• Receiver Architecture: Direct Down Conversion
• Dual 16 bit Phase Synchronous ADCs
• Independent filter banks for each ADC
• 6M LNAs
• Frequency Coverage: 9Khz to 60MHz
• Attenuator: 1-30dB step attenuator
• Reciprocal Mixing Dynamic Range (RMDR): 116dB @ 2Khz offset
• Receiver Phase noise: -149dB @ 10Khz
• Image rejection: 90dB
• Hardware support for 10 independent receivers assignable to either ADC
Transmitter Specifications:
• Transmitter Architecture: Direct Up Conversion
• DAC Resolution: 16 bit
• RF Output Power: 100W PEP SSB, FM, RTTY, Digital; 1-30W AM, 100W CW
• IMD: IMD3 typically -68dB below PEP @ 100W output on 20M
• Harmonics: Typically better than -43dBc on HF and -60dBc on 6M
• Carrier and Opposite Sideband Suppression: Better than -80dBc
• Transverter IF Output: 0dBm to 15dBm
Front Panel Specifications:
• 7” touchscreen display, 1024x600 pixels
• 1 high resolution VFO encoder (480 steps per revolution)
• Dual shaft encoders for analogue controls, with user programmable functions
• User programmable pushbuttons
To Next Page
Loading...