In fact working with 100V loudspeakers is rather simple, when done in the right way. Each 100V
loudspeaker has a 100V transformer which can be set to a certain power, for example: 1,5 3
or 6W. As the example shows, the sum of all loudspeaker settings should never exceed the
amplier’s power specications. Never use low impedance (= 8 ohm) loudspeakers on a 100Volt
system, even not one.
More technically: When your paging amp has a maximum output of 200 watts at 100V, this
means that the minimum impedance connected should be at least 50 ohm (100x100/200). To
check your loudspeaker lines use a decent impedance checker (example AP WM100).
Now you are ready to get the best result on distributing your music and messages to your
audience.
Your little giant is like a Swiss knife which will astonish you and many others!
Find more interesting audio solutions at www.apart-audio.com
6. How To Deal With 100V Loudspeaker Systems
To Next Page
Loading...
