E-ITN 40
Manual for installation service and operation M2021/8a EN
5. OTHER INFORMATION ABOUT PRODUCT
5.1. ELECTRONIC SEAL REACTIVATION
The electronic seal is used for detection if allocator was removed from back plate – more in chapter 2. If you
need to re-fit allocator (e.g. replace old radiator with new radiator), it is necessary to reactivate the seal.
1. Insert new latch into allocator. If use the old one, please check its condition, especially electro-
conductive rubber.
2. Secure the latch with mechanical seal.
3. Read allocator with NFC
4. Install allocator to the radiator.
5.2. TRANSPORTATION
E-ITN 40 allocators can be transported under following conditions:
• devices can be transported by all usual covered means of transport
• devices must be in original package
• originally packed devices must be stored and secured to avoid mechanical damages during
transportation
• devices can not be transported together with aggressive substances
• temperature during transportation from 0 °C to +55 °C
• relative humidity from 45 % to 75 %
5.3. STORAGE
E-ITN 40 is an electrical device and can be stored under these conditions:
• devices must be originally packed by manufacturer and individually stored in antistatic bags
• storage temperature from +10 °C to +30 °C
• relative humidity from 45 % to 75 %
• devices must be stored in clean covered areas without aggressive substances and stored properly to
avoid mechanical damage
5.4. APPLICATION AND DISPOSAL
"This device is subject to a waste management in accordance with local legislation." More
information on www.metra-su.cz
5.5. DEFECTS AND THEIR ELIMINATION
Any E-ITN 40 defect should be repaired by manufacturer only.
5.6. WARRANTY
If device is installed and handled according to manufacturer instructions mentioned in Installation and service
manual, manufacturer provide warranty under the valid legislation unless agreed differently.
The warranty is void if device was used contrary to Installation and service manual or damaged:
• during transport or storage by customer or reseller
• when mounted or dismantled to the customer device
• because of improper handling or installation into other device than agreed in manual
• if the product was exposed to different environment than agreed in manual
• if mechanically or in other way damaged by user
13 / 22
To Next Page
Loading...
Need help?
General