Need help?Do you have a question about the APC 2200 VA and is the answer not in the manual?
Explains the function of the APC UPS for protecting electronic equipment from power disturbances.
Instructions on how to unpack the UPS, check contents, and inspect for damage.
Lists technical specifications like temperature, humidity, weight, and storage limits.
Details on installing the UPS rails in a rack, referring to the rail kit instructions.
Step-by-step guide to physically mounting the UPS in the rack and connecting the battery module.
Information about the SmartSlot accessory and installing accessories before connecting power.
Instructions for connecting power, grounding, and plugging in equipment to the UPS.
Diagrams showing the rear panel layout for 120 VAC and 230 VAC UPS models.
Steps to start the UPS, battery charging, and installing monitoring software.
Details on using Serial and USB ports, noting incompatibility and simultaneous use restrictions.
Explains the EPO feature, its connection requirements, and cable types for system connection.
Visual representation of display panels for 120 V and 230 V models with load and battery charge indicators.
Table explaining the meaning of each indicator LED and related function buttons on the display panel.
Describes the UPS diagnostic feature to check utility voltage using LED indicators.
Explains the function of key buttons like Power On, Power Off, Self-Test, and Cold Start.
Details on how UPS settings are adjusted via software or optional accessory cards.
Configuration for the automatic self-test interval of the UPS.
Setting a unique identifier for the UPS for network management purposes.
Instructions to reset the date after replacing the UPS battery module.
Configures minimum battery charge percentage before powering equipment after shutdown.
Adjusts how the UPS reacts to voltage distortions, protecting connected equipment.
Options to mute or disable ongoing UPS alarms permanently.
Sets the delay between a shutdown command and the actual UPS shutdown.
Configuration of the low battery warning interval for unattended shutdowns.
Sets the delay before the UPS starts up after utility power returns.
Configures the voltage threshold for transferring to battery due to high utility voltage.
Configures the voltage threshold for transferring to battery due to low utility voltage.
Sets the output voltage for 230 V UPS models.
Instructions for safely replacing the hot-swappable battery module.
Steps to follow if the UPS requires service, including contacting customer support and return procedures.
Solutions for UPS not turning on or off, and operating on battery with line voltage.
Interpretation of beeps, LED status lights, and general indicator behavior.
Addresses insufficient backup time and battery-related issues.
Troubleshooting overload, wiring faults, and AVR voltage conditions.
Explains power status, simultaneous LED flashing, and specific LED meanings.
Lists FCC compliance, agency approvals, and RF warnings for UPS models.
Details the terms and conditions of the product's limited warranty.
Declares conformity with EU standards and directives for the equipment.
Information on how to contact APC customer support through various channels.
General| Brand | APC |
|---|---|
| Model | 2200 VA |
| Category | Power Supply |
| Language | English |
To Next Page