Need help?Do you have a question about the APC Automatic Transfer Switch and is the answer not in the manual?
General| Type | Automatic Transfer Switch |
|---|---|
| Input Frequency | 50/60 Hz |
| Output Frequency | 50/60 Hz |
| Mounting | Rack-mountable |
| Rack Height | 1U |
| Transfer Time | 8-12 ms |
| Humidity | 0-95% non-condensing |
Provides information on user guides and related topics for the Automatic Transfer Switch.
Instructions on recycling shipping materials.
Steps to inspect the package and contents for shipping damage or missing parts.
Lists the components included in the product package.
Details the components and functions of the Automatic Transfer Switch front panel.
Instructions for attaching mounting brackets to the Automatic Transfer Switch.
Steps to disassemble adjustable brackets for rack mounting.
Guides on attaching rear bracket segments to the rack.
Instructions for attaching front bracket segments to the switch.
Procedure for mounting the ATS into an enclosure or rack.
Explains the TCP/IP settings required for network operation.
Lists methods for configuring TCP/IP settings like IP address, subnet mask, and gateway.
Describes using the wizard to discover and configure ATS IP settings.
Explains how BOOTP and DHCP servers can be used for TCP/IP configuration.
Details configuring TCP/IP settings using a BOOTP server.
Summarizes how DHCP servers configure network settings for the ATS.
Introduces interfaces used to access the unit after network setup.
Explains accessing the ATS via a web browser using HTTP or HTTPS.
Describes accessing the control console via Telnet or SSH for configuration and management.
Explains using SNMP for monitoring and managing the Automatic Transfer Switch.
Details using FTP/SCP for firmware transfer and log file access.
Provides steps for connecting and configuring the ATS via a serial console.
Explains using ARP and Ping for remote console access and IP configuration.
How to configure the ATS sensitivity to power fluctuations.
How to set acceptable voltage ranges for ATS power source switching.
Details the terms and conditions of the product's factory warranty.
States that the warranty is only for the original purchaser.
Lists conditions and situations not covered by the warranty.
How customers can access support for warranty claims.
FCC compliance statement for Class A digital devices.
Canadian compliance statement for Class A digital apparatus.
VCCI compliance statement for Class A information technology equipment.
To Next Page