APC Smart-UPS VT Manual

990-2282A-001 Smart-UPS® VT 10-40 kVA 400V, 208V, 200V – Operation 7
Operation Procedures
How to turn into bypass
Single System – turning into internal bypass.
Caution
The load is not protected by the UPS and the power is not conditioned when the internal
mechanical bypass lever is activated.
Warning
In bypass operation the batteries are still charged. If a total power off is required, the batteries
must be pulled out to the red disconnect line, see the section How to perform a total power off.
Note
This procedure is not applicable to parallel systems as the internal mechanical bypass lever is
unavailable.
Note
If the UPS is running and controllable through the display, carry out steps 1 through 5. If not,
go directly to step 6.
 


Check that the UPS is in bypass. The green
(LOAD ON) and the yellow (BYPASS) LEDs
are lit.

Remove the Front Panel from the UPS (see
the Receiving and Unpacking sheet referred
to under the section Companion manuals).
Chrg 100%
Load 000%
xxxVin 000Vout x0Hz
Runtime: 0hr 0m
Press
Control
Status
Setup
Logging
Display
Diags
Help
Use
Press
UPS into Bypass
Do Self Test
Simulate Power Fail
Start Runtime Cal
Use
Press
Confirm:
UPS into Bypass
NO, ABORT
YES, UPS into Bypass
Use Press

APC Smart-UPS VT Specifications

General

Noise level	55 dB
Output power	24000 W
Input frequency	40/70 Hz
Maximum current	41 A
Output power capacity	30 kVA
Emergency Power Off (EPO)	Yes
Battery type	VRLA
Dimensions (WxDxH)	559 x 813 x 1499 mm
Nominal input voltage	400 V
Certification	C-tick, CE, EN 50091-2, EN/IEC 62040-3, IEC 61000-3-2, IEC 61000-3-3, ISO 14001, ISO 9001, VFI-SS-112
Product color	Black
Battery recharge time	5 h
Operating altitude	0 - 999.9 m
Non-operating altitude	0 - 15000 m
Storage temperature (T-T)	-15 - 45 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 95 %
Harmonized System (HS) code	85078000

Weight and Dimensions

Weight	629090 g
Package weight	660000 g