APC UPS - Battery Module Replacement Steps; Model-Specific Battery Removal; Battery Disposal and Recycling

9
1500VA Model
Step 3
Pull the battery module out of the compartment
until the back of the module is flush with the
outer edges of the UPS.
Disconnect the battery connector.
1000VA Model
Step 3
Disconnect the battery cable terminals before
removing the battery module from the UPS.
Note: The red cable connects to the red color-
coded terminal; the black cable connects to the
black color-coded terminal. This will be impor-
tant during the battery replacement procedure.
Be sure to deliver the spent battery to a recycling facility or ship it to APC in the re-
placement battery packing material.
Battery
Terminals
Step B
Step A
Battery
Terminals