GB
4
Regulator Owner’s Manual
............................................................................................
Introduction
Congratulations—and thank you—for choosing Apeks. All Apeks regulators
have been designed and manufactured with pride, according to standards
which meet or surpass all requirements for the BS EN ISO 9001:2015
quality control system.
Your Apeks regulator is covered by Apeks’ Limited Lifetime Warranty
against defects in materials or workmanship. This warranty is only
extended to the original purchaser, and is not transferable. For more
information, be sure to read the warranty section of this manual, and
remember to save your sales receipts. Copies of these receipts must be
presented whenever obtaining warranty service.
Perhaps more than any other piece of diving equipment you will own,
your regulator’s function and performance relies greatly on the care and
maintenance it will receive, in addition to regularly scheduled dealer
service. Before you dive with your new Apeks regulator, it is therefore
important to read this manual in its entirety to become familiar with its
features, as well as the correct procedures for setup, pre-dive inspection,
and post-dive maintenance.
Please read on to learn how you can obtain the maximum enjoyment from
your regulator, and maintain its like-new performance for many years to
come.
WARNING: Improper use or misuse of SCUBA equipment may result
in serious injury or death. Read and understand this owner’s manual
completely before diving with your Apeks regulator.
NOTE: Apeks demand regulators have been examined by DNV GL,
Brooktorkai 18, 20457 Hamburg, Germany, notified body for PPE
identification number 0098 with the following exception; MTX, MTX-R
demand regulators (including variants) which have been examined by
INPP, Port de la Pointe Rouge - E3 - BP. 157 - 13267 Marseille CEDEX
08-FRANCE, notified body for PPE identification number 0078
NOTE: All Apeks regulators have been tested and certified in accordance
with prEN250:2012 to a depth of 50 metres and prEN250:2012 Annex A;
Auxiliary Emergency Breathing Systems to a depth of 50 Metres. See
further note below.
To Next Page
Loading...
Need help?
General
