To Next PageTo Next Page
Need help?Do you have a question about the Apeks XTX FSR and is the answer not in the manual?
Defines standard terms, directional actions, 'O' Ring removal, and acronyms used in the manual.
Step-by-step guide on how to safely remove hoses from the first stage regulator.
Instructions for removing medium and high pressure blanking plugs from the regulator.
Procedure for disassembling the high pressure balance plug assembly.
Steps for removing the environmental end cap and load transmitter.
Procedure for disassembling the DIN connection assembly.
Steps to remove the yoke clamp, connector, and disc filter.
Instructions for removing the HP valve seat specific to the FSR model.
Guide for installing the HP valve seat using the correct tool for FSR models.
Procedure for reassembling and fitting the yoke connection to the regulator.
Steps for reassembling and fitting the DIN connection to the regulator.
Instructions for fitting the diaphragm, spring carrier, and diaphragm clamp.
Attaching the first stage to a cylinder and initial pressurization for cleaning.
Procedure for testing and adjusting the medium pressure to the correct range.
Procedure for installing the load transmitter and hydrostatic diaphragm.
Tightening the environmental end cap and re-checking medium pressure.
Procedure for submerging the regulator in water to check for air leaks.
Symptoms, possible causes, and treatments for high pressure creep issues.
Troubleshooting external air leaks and diaphragm-related problems.
Causes and solutions for restricted air flow and high inhalation resistance.
Steps for cleaning all regulator components using ultrasonic baths and warm water.
Guidance on applying lubricants to 'O' rings and avoiding excessive amounts.
Safety and compatibility guidelines for using regulators with Enriched Air Nitrox.
Defines standard terms, directional actions, 'O' Ring removal, and acronyms used in the manual.
Step-by-step guide on how to safely remove hoses from the first stage regulator.
Instructions for removing medium and high pressure blanking plugs from the regulator.
Procedure for disassembling the high pressure balance plug assembly.
Steps for removing the environmental end cap and load transmitter.
Procedure for disassembling the DIN connection assembly.
Steps to remove the yoke clamp, connector, and disc filter.
Instructions for removing the HP valve seat specific to the FSR model.
Guide for installing the HP valve seat using the correct tool for FSR models.
Procedure for reassembling and fitting the yoke connection to the regulator.
Steps for reassembling and fitting the DIN connection to the regulator.
Instructions for fitting the diaphragm, spring carrier, and diaphragm clamp.
Attaching the first stage to a cylinder and initial pressurization for cleaning.
Procedure for testing and adjusting the medium pressure to the correct range.
Procedure for installing the load transmitter and hydrostatic diaphragm.
Tightening the environmental end cap and re-checking medium pressure.
Procedure for submerging the regulator in water to check for air leaks.
Symptoms, possible causes, and treatments for high pressure creep issues.
Troubleshooting external air leaks and diaphragm-related problems.
Causes and solutions for restricted air flow and high inhalation resistance.
Steps for cleaning all regulator components using ultrasonic baths and warm water.
Guidance on applying lubricants to 'O' rings and avoiding excessive amounts.
Safety and compatibility guidelines for using regulators with Enriched Air Nitrox.
General| Brand | Apeks |
|---|---|
| Model | XTX FSR |
| Category | Controller |
| Language | English |
