Apeks WTX-D - Page 26

Table of Contents
© 2014 Apeks
Original WTX Harness
No Center Webbing Loop
Current WTX Harness
Center Webbing Loop
GripLock
Patch
1. Set the buoyancy cell on a at surface with the zipper side face up. Remove the bail from the cylinder
band. Insert the GripLock™ band through the upper right oval grommet hole with the GripLock™ patch
facing up.
NOTE: You must have a current model WTX harness that has the center webbing loop in order
to use a WTX-D single cylinder buoyancy cell. The original WTX harness does not have a center
webbing loop and, therefore it is not compatible with a WTX-D single cylinder buoyancy cell.
NOTE: The original and current WTX harness are compatible with all WTX-D twin cylinder
buoyancy cells.