API THUNDER 125 - Page 22

Brakes
Fluid Level Inspection
Front Brake Fluid Level Check
(1)
(1) LOWER level mark
With the motorcycle in an upright position,
check the fluid level.
It should be above the LOWER level mark (1). If
the level is at or below the LOWER level mark,
check the brake pads for wear .
Worn brake pads should be replaced. If the
pads are not worn, have your brake system
inspected for leaks.
If the front brake lever freeplay exceeds 0.8 in
(20 mm), there is probably air in the brake
system and it must be bled. See your motorcycle
dealer for brake bleeding.
Rear Brake Fluid Level Check
(2)
(2) LOWER level mark
With the motorcycle in an upright position,
check the fluid level.
It should be above the LOWER level mark (2).
If the level is at or below the LOWER level
mark, check the brake pads for wear .
Worn brake pads should be replaced. If the
pads are not worn, have your brake system
inspected for leaks.
If the rear brake pedal freeplay exceeds 0.8 in
(20 mm), there is probably air in the brake
system and it must be bled. See your otorcycle
dealer for brake bleeding.
Service Procedures 22