Wheels
Maintenance of spoke tension and wheel trueness
(roundness) is critical to safe motorcycle
operation. During the first 100 miles (150 km),
spokes will loosen more rapidly due to the initial
seating of the parts. Excessively loose spokes
may result in instability at high speeds and the
possible loss of control. It’s also important that
the rim locks are secure to prevent tire slippage.
See the motorcycle dealers for inspection
1. Check the axle shaft for runout.
2. Check the condition of the wheel bearings.
(3)
(2)
(1)
(1) wheel rims
(2) spokes
(3) rim lock
1. Inspect the wheel rims (1) and spokes (2) for
damage.
2.Tighten, any loose spokes and rim locks (3)
to the specified torque:
Spoke : 2.7 lbf•ft (3.68 N•m, 0.38 kgf•m)
Rim Lock : 9.4 lbf•ft (13 N•m, 1.3 kgf•m)
3.Check wheel rim runout. If runout is
noticeable, see the motorcycle dealers.
Service Procedures 25
To Next Page
Loading...