APlusLift MT1500 - Expert Maintenance and Repairs

volume: 2017 D/P
18 of 24
6. Maintenance
6.2 Weekly Maintenance
• Checkairhosesandttingsforleaksandmakesureconnectionsaretightened.
• Checkallbolts,nuts,shafts,retainingclips,retainerrings,setscrewsandscrews,ensure
they are aligned in proper place (grooves), secured, and tightened properly. Pivot Shaft set
screws should always be checked to ensure that they are tight.
• Check
theCylinderRod,ifitbecomesdry,lightlyoilit.
• Lubricate
thegreasezerkslocatedateitherendofthePivotShaft.
• Lubricate
thegreasezerksatthetopendoftheinsideframeassembly.
6.3 Six Month Annual Maintenance
• LubricatethegreasezerkslocatedateitherendofthePivotShaft.
• Lubricatethegreasezerksatthetopendoftheinsideframeassembly.
• SquirtsomeoilthroughthebleedholeinthePlateEndoftheCylindertolubricatethePiston.
6.4
The following repairs should only be performed by a APlusLift
authorized trained maintenance expert:
• Replacementofshafts/axles.
• Replacementofrollbearings.
• Replacementorrebuildingpneumatic/aircylinders.
• Checking
pneumaticcylinderrodsandrodends(threads)fordeformationordamage.
• Checking
cylindermountingtomakesureitsnotloseand/ordamage.
Relocating or changing components may cause problems. Each component in the system must
be compatible; an undersized or restricted line will cause a drop in pressure. All Foot Peddle,
and hose connections should be sealed and/or capped until just before use. Air hoses can be
usedtocleanttingsandothercomponents.However,theairsupplymustbelteredanddryto
prevent contamination. Most important - cleanliness - contamination is the most frequent cause
of malfunction or failure of pneumatic equipment, so always use an oil/air regulator.
APlusLift MT1500 & MT1500X
INSTALLATION Manual
www.apluslift.com
Questions? Problems? Call Us At 425-209-0838