NOTE
A component can be qualified as operated „On condition” only, if it can be
continuously surveyed during operation. The Contact Point person may advise
Apollo to change this qualification.
Whole Hang block Assembly – including hang bolt
All nuts and bolts of mast/pylon
All brackets like the compression strut securing brackets etc.
Front suspension bolts/nuts
Rear suspension securing bolts to base tube (x4)
Rear axle bracket to landing gear securing bolts (x8)
Rear axle to axle bracket securing bolt (x4 – 2 per axle)
Front Fork Shock Absorbers
All airframe ball-joints, bolts and nuts
Flush and bleed the brakes using correct tool and DOT 4
fluid from a sealed container for Delta Jet and Automatic
Transmission Fluid (ATF aka 5606 milspec) for Monsoon
If brakes start
to feel spongy
All rear suspension components (landing gear)
Metal Airframe components
On condition for trike carriage
and every 1500 H for wing
tubing skeleton and sail
As needed on condition or 950
Hours or 8 years
Fuel – Primer Bulb (if applicable)
Fuel – Filter (Use only fuel filter approved for engine and
proper for he type of fuels used like Ethanol based gas)
Hose – Oil (AeroEquip or Parkerhose)
Rubber Mounts (all) – Need special tool to press in the
rubber. Can be ordered from the factory with the
rubber mounts
Cables and housing – Throttle and Choke
Engine Mount Nuts and bolts
All engine mount components