Apollo Panda - ANNEX B - AL1206 Removal from Steel Deck Adherence

Solarpaint
AL1206 Installation Manual
14.9.2023
Rev. [B1]
Page 24 of 28
ANNEX B – AL1206 removal from steel deck adherence
1. Safety:
a. Beforere module removal, Ensure the module is not connected to the grid.
b. Follow all safety instructions warnings and limitations in the "safety" chapter of this
document.
c. the removal process causes permanent damage to the modules! Do not try to
re-install or re-use removed modules in any case – this may cause electrocution and fire
hazard.
2. Required tools:
a. Utility knife.
b. Protective gloves.
3. Required personnel: minimum 2 workers.
4. Module removal procedure:
Using a utility knife, cut between the side adhesive lines of each module while applying force to separate
the module from the substrate