Solarpaint
AL1206 Installation Manual
14.9.2023
Rev. [B1]
Page 5 of 28
• Do not remove the labels attached to the module
• Upon module electrical connection, verify visually and audibly that all connectors are properly
fastened. When reaching the correct position, an audible "click" sound should be heard
• Do not expose the PV module to excessive loads on the surface of the PV module or twist the module
Always use common sense to avoid injury. When in doubt, contact an Apollo Specialist for assistance
at info@apollo-power.com
• Modules should be stored in a dry and ventilated environment and avoid direct sunlight and moisture
• Do not stack more than 2 pallets in height. Excessive stacking will result in product
damage and loss of warranty.
• In case the modules are stored in an uncontrolled environment, the storage time should be less than
1 month extra precautions should be taken to prevent connectors from being exposed to moisture
or sunlight (using connector endcaps, covering the pallet and module packages with a material fit for
the environmental conditions on site)
• Unpack module pallets carefully, be sure not to penetrate the package with any sharp
object as it may damage the modules.
• Modules must always be unpacked and installed by two people.
• Installers must consider the maximum bend radius of the installed module which may not exceed it.
• Keep the modules packed in the original package until installation
Apollo solar modules are 95% recyclable and to be disposed of per WEEE (Waste Electrical and Electronic
Equipment) Directive 2012/19/EU. the modules do not contain environmentally \ human harming
materials. Please contact us for any disposal information and quarries.
To Next Page
Loading...