• The instructions related to safety and use indicated in this installation manual are intended for the
prevention of unexpected danger, damage, or failure. Please notice the markings when indicated:
• Non-compliance with the instructions may cause product damage, product failure, and/or serious
injury or death and void the product warranty.
• Do not contact electrically active parts of the panel, such as terminals, without appropriate safety
gear. Contact may result in a lethal spark or electric shock
• Do not use or install if the module is broken or torn. Failure to comply may result in an electric shock
• Due to the risk of electrical shock, do not perform any work if the terminals of the PV module are
wet
• Damaged modules must be treated by professional experts using safety protection equipment
Failure to comply may result in severe injury or death
• Do not approach the damaged or broken module unless you are an authorized or qualified expert.
Failure to comply may result in severe injury or death
• Installation during rain, heavy wind, or snowy day may result in injury or death
• Always wear protective gear, insulated gloves, and safety shoes
• Perform all work in dry conditions and use only dry tools
• Do not reconnect or repair the junction box cable. It may cause a spark or electric shock
• Do not bend the junction box's cable. While under stress, it may cause module damage
• The minimum module bending diameter is 1000 mm, an attempt to overbend the module will
damage the module and void the warranty
• Cable bending radius should be larger than 4 times the cable diameter
• Apollo AL1206 shall only be installed on Non-combustible surfaces
• Heavy objects must be kept off the module
• Do not stand on or step on the module
• Do not drop the module. Failure to comply may result in product damage, product failure, or injury
• Do not scratch the surface of the module. Scratches may decrease Module's power output
• Do not artificially concentrate sunlight on the solar module surface. Failure to comply may result in
product damage or failure.
• Do not carry or handle the Module by the junction box of the module by the cable. Failure to comply
may result in product damage
To Next Page
Loading...