Apollo XPander User Manual

5
© Apollo Fire Detectors Limited 2015
Quick Start Guide for XPander Diversity Loop Interface
1. Select the interface number
or ID (range 1-5).
2. Select channels following
Appendix B and checklist on
the inside of the unit.
3. Set the address for the
system.
4. Log on devices to the
interface (for each interface).
For detailed instructions see page 07
For detailed instructions see page 13
For detailed instructions see
Installation Guide 39214-926
For detailed instructions see page 08
Quick Start Guide for XPander Diversity Site Survey
1. Use the site survey tool to
check the signal strength.
2. Record all the survey signal
strengths on the site survey
sheet.
3. Fit the interfaces - as per
instructions in the quick start
guide below.
4. Log the devices on to the
interface - as per instructions in
the quick start guide below.
5. Check the signal strength
for each logged on device and
record on the site survey sheet.
For detailed instructions see page 16
For site survey sheet see page 17
See Quick Start Guide for XPander
Diversity Loop Interface below
For detailed instructions see page 08
For site survey sheet see page 17

Apollo XPander Specifications

General

Brand	Apollo
Model	XPander
Category	Security Sensors
Language	English