17
* CAUTION : Limit large current measurements ( 10 to 20A) to 30 seconds
and allow two minutes of cooling between measurements.
* Do not connect to circuits with > 600V.
* The AC and AC + DC measurements provide true RMS.
* In AC mode, the frequency of the measured signal ≧ 20% of full scale is
displayed simultaneously.
5.7 CAPACITANCE MEASUREMENTS
* Set dial.
* Connect leads, zero stray capacitance for low capacitance measurements.
* CAUTION : Remove all power from the circuit and discharge Capacitor to be
measured before connecting the test leads.
* Remove individual components from circuit for best results.
To Next Page
Loading...
