62
use and maintenance Pegaso 650 I.E.
◆ Pull the engine oil filter (9) and clean it
with a jet of compressed air.
◆ Check the seal of the engine oil filter (9)
positioned on the tank; screw and tighten
it.
Engine oil filter (9) driving torque: 35
Nm (3.5 kgm).
◆ Connect the pipe (12) and tighten the
new clamp (10).
aCAUTION
Do not put additives or other substanc-
es into the oil.
If you use a funnel or other similar
items, make sure that they are perfectly
clean.
NOTE Use high-quality 5W – 40 oil, see
p. 104 (LUBRICANT CHART).
◆ Pour about 1600 cm# of engine oil
through the filling opening (13), see p.
104 (LUBRICANT CHART).
◆ Screw the plug-dipstick (3).
◆ Put back the fuel tank, see p. 72 (RE-
MOVAL OF THE FUEL TANK).
◆ Put back the oil sump guard, see p. 73
(REMOVING THE OIL SUMP GUARD).
◆ Start the engine, see p. 44 (STARTING)
and let it idle for about one minute, in or-
der to ensure the filling up of the engine
oil circuit.
◆ Check the oil level and top up if neces-
sary, see p. 59 (CHECKING THE EN-
GINE OIL LEVEL AND TOPPING UP).
!)2#,%!.%2
Check the air cleaner every 6000 km (3750
mi) or 12 months, change it every 12000 km
(7500 mi) or more frequently if the vehicle is
used on dusty or wet roads.
It is possible to clean the air cleaner partially
after using the vehicle on this kind of roads.
aCAUTION
The partial cleaning of the filter does not
exclude or postpone the replacement of
the filter itself. Do not start the engine if
the air cleaner has been removed. Do not
clean the filtering element with petrol or
solvents, since they may cause a fire in
the fuel supply system, with serious dan-
ger for the persons in the vicinity and for
the vehicle.
DO NOT DISPOSE OF POLLUTING SUB-
STANCES OR COMPONENTS IN THE
ENVIRONMENT.
To Next Page
Loading...
Need help?
General
