APsystems DS3-M - Step 6 - Install a Bus Cable End Cap at the End of AC Bus Cable

APsystems Microinverter DS3 series Installation manual
11
4. APsystems Microinverter System Installation
AC connector interface as from left to right.
Figure 6
Cover any unused connectors with Bus Cable Y-CONN Cap to protect the unused connectors.
Figure 7
4.3.6 Step 6 - Install a Bus Cable End Cap at the end of AC bus cable
Figure 8
A. Strip cable jacket.
B. Insert the cable end into the seal.
C. Rotate the nut with 3.3N·m until
the latching mechanism meets the base.