APsystems ECU-C - 3.3 Cable Connections; 3.4 RJ45 Signal connection; 3.5 Internet Connection

ECU-C Installation/User Manual
9
3.Hardware Installation
3.3 Cable Connections
Power Connection Port
Network port RJ45 Signal
Figure 9

Connect the power cable to the power connection port on the top
of the ECU-C.(Can also be DC power supply).
 Connect the supplied LAN cable to the network port on the bottom
of the ECU-C.
3.4 RJ45 Signal connection
Plug the RJ45 connector in the package to RJ45 Signal port.
3.5 Internet Connection
There are three different approaches to connecting the ECU-C to the
Internet:
Option 1: Direct LAN cable connection.
1) Make sure the LAN cable is connected to the network port on the
bottom of the ECU-C.
2) Connect the LAN cable to a spare port on the broadband router.
Figure 10