APsystems ECU-C - 7.1 ECU-C Configuration;ECU-C Status Page

ECU-C Installation/User Manual
40
7.Remote ECU-C Management (EMA)
7.1 ECU-C Configuration/ECU-C Status Page
ECU-C SETTING page under the Remote control page.
Figure 24
The ECU-C SETTING tab allows you to:
Set Time Zones
 The ECU-C time zone can be set or adjusted remotely through the
ECU-C setting tab. If the time zone is not properly set, the solar
production data will not post properly on the EMA site.
Load Inverter IDs
 Once the ECU-C has been installed you can access the ECU-C
remotely to add the inverter IDs. Until the inverter IDs are loaded,
the ECU-C will not be able to collect data from the inverters.
Update Inverter ID list
 If an inverter(s) is added or swapped for a new unit, then the
ECU-C’s programmed list of inverters will need to be updated.