ECU-C Installation/User Manual
7.Remote ECU-C Management (EMA)
Operation Selection (Add or Delete)
Figure 27
Adding Complete List of Inverter IDs for a Newly Installed System
There are two different approaches to add the inverter IDs:
Option 1: Webpage -
1. Select Add inverter based on registration list
1) Select “Add” in Operation Selection.
2) Select the Inverters“select from below list”.
3) Select the inverter to be added
4) Press “Send”.
2. The specified inverter ID
1) Select “Add” in Operation Selection.
2) Select the Inverters“input the special ones”.
3) Enter all of the inverter IDs into the Inverter ID Field(one per line).
4) Press “Send”.
Option 2: Mobile phone-
1) Log onto ArrayAPP.
2) Select user account.
3) Select Link ECU.
4) Press “Send”.
Delete IDs from Inverter List
1. Select Delete inverter based on registration list
1) Select “Delete” in Operation Selection.
2) Select the Inverters“select from below list”.
3) Select the inverter to be deleted.
4) Press “Send”.
2. The specified inverter ID
1) Select “Delete” in Operation Selection
2) Select the Inverters“input the special ones”.
3) Enter all of the inverter IDs into the Inverter ID Field(one per line).
4) Press “Send”.
3. Delete all
1) Select “Clear” in Operation Selection.
2) Press “Send”.
To Next Page
Loading...
