b. For geographical areas having special requirements, the external grounding can be done by using the
grounding brackets.
Step 5. Connect the APsystems microinverter to AC bus cable
Push the microinverter AC connector to the trunk cable connector. Listen for the "Click".
NOTE: AC connector interface as follows. NOTE: Cover any unused connectors with
Bus Cable Y-CONN Cap to protect the connectors.
Step 6. Install a Bus Cable End Cap at the end of AC bus cable
a. Strip cable jacket. c. Insert the wires into the cable clamps.
b. Insert the cable end into the seal. d. Rotate the nut with 3.3N·m until the
latching mechanism meets the base.
To Next Page
Loading...
