APT APT-1 - Page 18

To Next Page

To Previous Page

APT-1 – User’s Manual (EU) Rev. 2019-01 en for il 18

9.4. COMBINED active/passive mode

Step 1: Operate the APT-1 in the passive mode and work against the

force of the motor by applying resistance to the rotation of the

crank arms.

Step 2: The resistance force to the rotation is displayed on the on the

Bar Indicator as a percentage (%) at each level.

Step 3: If the resistance force stops the crank arm rotation completely,

the Bar Indicator (Figure 3-5) reaches 100% and the red indi-

cator will light up. After holding this position for approximately

2 seconds, the crank arm rotation will stop automatically.

NOTE: To restart, Press the button for forward rotation, or the

button for backward rotation.

9.5. Passive mode - AUTO-REVERSE function

Step 1: Push the button to activate the AUTO-REVERSE function

in the PASSIVE mode. The green indicator will light up.

Step 2: Operate the APT-1 as in usual passive or combined ac-

tive/passive mode.

Step 3: When the resistance force stops the crank arm rotation com-

pletely, the Bar Indicator (Figure 3-5) reaches 100% and the

red indicator will light up. After holding this position for approx-

imately 2 seconds, the crank arm rotation will stop automati-

cally. After a short delay the DIRECTION OF ROTATION

WILL BE REVERSED. This feature also serves as an ANTI-

SPASM function, stopping the motor in case of muscle spasm

and reversing the direction of rotation after a short delay.

Step 4: As long as the button indicator is lit, this function will con-

tinue to operate in the PASSIVE mode.