Aputure Light Storm - Dual Battery Power Supply; V-Mount Battery Powered; Operations and Controls

* When using dual battery power supply, install the battery in the battery slot corresponding to the red/black lock key successively; When removing the battery, press the red/black lock
button and then pull out the battery one by one. Do not pull it out forcibly..
* Rotate the red rotary ring of the DC input connector clockwise and then pull it out to remove the battery case. Do not pull it out forcibly
* Dual battery: Voltage 12~16.8V; Recommended ≥6.6A continuous discharge.
3) V -Mount battery powered
* V-mount batteries are available for purchase.
* Only use batteries that support the necessary continuous current discharge specifications mentioned above. If non-compatible batteries are used, the batteries will enter a protection state
and the lighting fixture will not operate as intended.
* Do not use a battery with a specification of more than 21V. Using the wrong battery will cause damage to the lamp.
* Press the V port seat button and pull out the V-Mount battery upward. Do not pull it out forcibly.
* Rotate the red rotary ring of the DC input connector clockwise and then pull it out to remove the D-tap to DC Cable. Do not pull it out forcibly.
Operations
1. Power on, the switch button can control the switching state of the Lamp Head.