6
Figure 6a
Figure 6b
Long
side of
pool
Power
Supply
NOTE: It is suggested to unplug your Power Supply when not in use to prevent accidental starts!
WARNING: The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge at all times!
WARNING: A Ground Fault Circuit Interrupter (GFCI) / Residual Current Device (R.C.D.) must be installed to
protect your electric outlet and to prevent any possible electrical shock!
2. CLEANER START POSITION
1. Holding the Handle, submerge your cleaner upside
down, and gently rock it back and forth under the water
to allow any trapped air to escape, which is critical for
proper balancing or it may not clean and cover your pool
as designed.
2. While submerged turn upright, then let go allowing your
cleaner to settle to a level area on the pool floor near the
shallow end. Starting it on an incline (like a deep end
hopper) may cause the cleaner, program and sensors to
mistakenly consider the incline as the floor, and conversly
on the floor as a wall. This would offset its cleaning
program and coverage, resulting in missed areas. Be
sure to start the cleaner on a level surface every time.
3. Turn ON Power Supply to begin cleaning.
Plug the Power Supply Cord into a standard Ground Fault Circuit Interrupted (GFCI) / Residual Current Device (R.C.D.)
protected outlet. If your GFCI outlet is too far away and your cleaner does not have enough Cable to properly enter the
pool at the midpoint of its longest side then you may use a proper outdoor grounded extension cord, but always keep the
Power Supply at least 12’ / 4 m from the pool’s edge!
The Power Supply (Fig. 4) should be placed in a sheltered
area, at least twelve (12) feet / four (4) meters away from
the pool at all times (Fig 6a). While the Power Supply
is weather-resistant, it is not waterproof and therefore
should be placed in an elevated dry area where it will not
be allowed to sit in puddles of water. Less is More: For
optimum cleaning performance locate the Power Supply
at the mid-point of your pool’s longest side (Fig. 6b). This
will allow your cleaner to make the best use of its length of
Floating Cable without using excess Cable length. Excess
Cable in the pool may result in it unnecessarily twisting,
kinking or getting entangled within your cleaner’s rotating
scrubbing Brush system. Excess Cable should be kept
coiled outside the pool near the Power Supply.
1. SETTING UP THE POWER SUPPLY
TIP! To help protect your Cable from potentially getting twisted, it is suggested to turn off your pool’s filtration system while
your cleaner is in operation to reduce the pool’s filter circulation effect that may push and circulate the Cable.
SETTING UP YOUR ROBOTIC POOL CLEANER
To Next Page
