Shower head systems installation instructions Page 10
Ceiling mounted fixed head
Run a 15mm outlet pipe from the processor/diverter to the preferred position for the fixed head.
1
This product must be installed by a competent person in accordance with the relevant Water Supply
Regulations.
In addition to the guide below, it is essential that the written instructions in the main product
installation instructions are read and understood, and that you have all the necessary components
(shown in the main product installation guide) before commencing installation.
The shower head and arm is supplied complete with a 2 year guarantee.
The shower arm and rail kit is supplied with universal fixings intended to secure it to a suitable wall.
Please follow the main product installation instructions to fit the shower controller and processor/
diverter units (depending on product purchased) prior to installing the shower head and rail kit.
!
!
!
!
The ceiling mounted fixed head is supplied with screws for fixing the product to a noggin.
A NOGGIN MUST BE USED AS PART OF THIS INSTALLATION.
!
Locate the position for the fixed head in the bathroom and firstly drill a
pilot hole to mark the position before checking that there is suitable
space behind the ceiling for the fixing assembly.
2
The minimum height required behind the ceiling is 50mm and the space must allow for an 80mm wide,
50mm deep noggin to be used to support the assembly.
!
To Next Page
Loading...
