Visage™ Digital Installation Guide 7
Refer to safety information section
The maximum hot water inlet temperature must be no more than 65˚C.
Flush through both hot and cold supply pipes.
5
Place the Quartz Smart Valve™ on a solid mounting surface, and
place the fixing feet into suitable positions. Mark, then drill and
prepare suitable fixings before securing the Quartz Smart Valve™
to the mounting surface using the screws provided, (if suitable).
4
Attach the supply pipes to the Quartz Smart Valve
™
, ensuring
that the cold and hot feeds are fitted into the appropriately
marked inlets.
6
Do not solder near to plastic components.
7
Run a pipe from the mixed water outlet of the Quartz Smart Valve™ to the proposed siting
for the shower hose outlet or exposed rail system, depending on the system purchased.
To ensure optimum performance we recommend using copper pipe with a minimum
number of elbows.
Proceed to the relevant Controller section (Concealed or Exposed).
To Next Page
Loading...
