What to do if my Aquasana AQ-SFRO has slow flow?
If you're experiencing slow water flow from your Aquasana Water Filtration Systems, first ensure water is flowing from the faucet. If it is, close the faucet and check the pressure again after one hour. If it’s been over six months since your last filter change, consider replacing the filters.
How to fix a water leak or drip in my Aquasana AQ-SFRO?
A leak in your Aquasana Water Filtration System can stem from a loose connection at the inlet/outlet. To address this, turn off the cold water valve beneath the sink. Then, depressurize the system by opening the faucet, which releases any trapped water. Also, ensure the color-coded tubing is correctly placed, cut tubing straight (not at an angle), and is fully inserted into the manifold. After reconnecting, turn the water back on and check for leaks. Confirm cartridges are locked. If leaking persists, shut off the cold water and contact Customer Support.
Details for setting up systems with and without a dedicated faucet.
Instructions for installing the air gap faucet, including important notes.
Detailed steps for installing the drain saddle onto the drainpipe.
Connect the inlet tee valve and tubing to the cold water supply.
Mount the system manifold and install the remineralizer bracket.
Steps for sanitizing the water tank and installing the tank valve.
Connect the water tank to the system manifold using yellow tubing.
Guide to connecting all system tubing, including inlet tee and faucet connections.
Instructions on how to correctly insert the filter cartridges into the manifold.
Procedures for testing, leak checking, and flushing the system after installation.
Important safety precautions and warnings for system installation and use.
Information on replacing Carbon Block and Advanced Carbon Block cartridges.
Details and schedule for replacing the SmartFlow™ Membrane filter.
Guidance on replacing the Remineralizer cartridge.
Details on system testing, certifications, and performance specifications.
Troubleshooting steps for addressing water leaks or drips in the system.
Answers to frequently asked questions about installation and system operation.
Addressing system noise and compatibility with different faucet types.
Guidance on filter disposal and understanding system operation.
Details on what the warranty covers, what is excluded, and how to get service.
Information on the Water for Life program, including discounts and extended warranty.
General| Filtration Method | Reverse Osmosis |
|---|---|
| Installation | Under Sink |
| Operating Water Pressure | 40-80 psi |
| Type | Reverse Osmosis |
| Filtration Technology | Reverse Osmosis |
| Filtration Stages | 4 |
| Contaminant Reduction | Arsenic, Chlorine, Fluoride, Lead |
| Filter Lifespan | 6 months to 2 years (varies by filter) |
| Daily Production | 42 gallons |
| Certifications | NSF/ANSI 58 |
| Stages of Filtration | 4 |
To Next Page