To Next PageTo Next PageWhat to do if the lamp is on but the Aquasana AQ-UV-C isn't disinfecting?
If the lamp in your Aquasana Water Filtration System is lit but not disinfecting properly, the UV output may be insufficient due to the lamp's age. Replace the lamp with the correct part, as indicated on the silver label on the reactor.
How to fix a lamp problem in Aquasana Water Filtration Systems?
If your Aquasana Water Filtration System detects a lamp problem, try these steps: First, reset the lamp protection circuit by unplugging the unit for 10 seconds. If the issue persists, replace the lamp with the correct part, as indicated on the silver label on the reactor.
General| Brand | Aquasana |
|---|---|
| Model | AQ-UV-C Series |
| Category | Water Filtration Systems |
| Language | English |
Instructions for mounting the UV reactor horizontally or vertically.
Procedure for installing the quartz sleeve and its O-ring into the reactor.
Guidance on safely installing the UV lamp into the reactor.
Connecting the lamp connector and ensuring proper electrical grounding.
Steps to disinfect the home's water lines after installation or service.
Detailed instructions for cleaning the UV system's quartz sleeve.
Identifying and resolving system issues indicated by hard alarms.
