4
www.AQUASUREUSA.com
Tel: 1-800-661-0680
III. Installation Safety Guide
• Handle with care when moving the water softening system. Do not turn upside down,
drop, drag, or set on areas with sharp protrusions.
• The system works on standard 110v power plug only. Do not use any other transformer
except the ones that is included with the system
• Transformer must be plugged into an indoor 120 volt, grounded outlet only.
• Use clean water softening salt only with at least 99.5% pure. Extra course grade or crystal
salt are recommended. Do not use rock, block, granulated or ice cream making salts. They
contain contaminants that could cause problems during maintenance
• Always keep salt lid in place on the softener unless servicing or relling the unit.
• All of our resin tanks have level adjusting tank bases. These tanks are designed to work
with a “oating” base. This allows the tank to be leveled on any surface. Some applications
may not have level surface to place the tank. The oating base allows the tank to be
leveled within the base and ensure proper operation. Sometimes the based can shift
during shipping. It can be adjusted back by lifting the tank up no higher than 5” - 10”, and
letting it drop to help level the base.
CORRECT CORRECTINCORRECT INCORRECT
To Next Page
Loading...
Need help?
General
