7
AQUASURE HARMONY SERIES
3. Install the upper basket on the bottom of the valve
by lining up the tabs, pressing in, then turning the
basket clock-wise to lock it in place.
4. Place the upper basket over the distributor tube
and push the valve on the tank. Thread the valve
on the tank by turning it clockwise. Be sure not
to cross-thread the valve on the tank. The valve
should thread easily in the tank. If not, it may be
cross-threaded.
5. Tighten the valve hand tight, then snug it further
by tapping it with the palm of the hand. DO NOT
use tools to tighten the valve or damage could
occur.
To Next Page
Loading...
Need help?
General
