12
7. Locate the UV lamp and connect the ballast plug to the lamp electrical prongs.
IMPORTANT: Do not turn on the system at this time and do not plug into
a wall outlet. Never expose or look at the UV lamp that is powered on.
Doing so can cause damage or loss of vision.
IMPORTANT: Handle the UV lamp gently to avoid damage or breaking the
glass lamp or quartz sleeve.
Open end
cap attached
to power
Closed end
cap
6. Determine which end of the UV system will be on top or will be receiving
power and connected to the ballast. Designate and install the open end cap on
this side of the UV system.
IMPORTANT: Hand tighten the end caps onto the UV chamber.
Overtightening or tightening with the use of tools could result in damage
to the quartz sleeve.
To Next Page
Loading...
