To Next PageTo Next PageWhat to do if my Aquatic Hot Tub chromatherapy doesn’t function?
If the chromatherapy feature in your Aquatic Hot Tub isn't working, check the following: * Ensure it's plugged in. * Replace the bulb if it's burned out. * Check for disconnected or defective wiring and reconnect if needed.
What causes low pump pressure in my Aquatic Infinity Hot Tub?
Low pump pressure in your Aquatic Hot Tub can be attributed to the pump running at reduced speed. Refer to the section on 'Motor does not reach full speed'.
What to do if the air blower in my Aquatic Hot Tub does not function properly while in the pulse or wave modes?
If the air blower in your Aquatic Hot Tub isn't functioning correctly in pulse or wave modes, try adjusting the air speed setting to a mid-range setting before switching to wave or pulse modes.
What to do if my Aquatic Infinity Hot Tub blower does not manually shut off?
If the blower in your Aquatic Hot Tub doesn't manually shut off, it could be due to a defective control panel or control box. Refer to your installer/dealer to replace the control panel or control box.
What causes leakage of water at the shaft of my Aquatic Infinity Hot Tub?
If there's water leaking at the shaft of your Aquatic Hot Tub, it indicates that the shaft seal requires replacement. Contact Aquatic for assistance.
What causes leaking unions in my Aquatic Infinity?
Leaking unions in your Aquatic Hot Tub can be due to a missing or damaged O-ring, plumbing being in a bind, or loose unions. Try tightening the unions. For missing or damaged O-rings or plumbing issues, contact Aquatic.
Steps to register the product to activate the warranty and contact information.
Steps to follow before commencing the installation of the whirlpool bath unit.
Guidelines for preparing the floor and framing for the whirlpool installation.
Instructions for installing the whirlpool bath unit with a factory-installed tile flange.
Procedure for connecting waste, overflow, and water valves for the whirlpool.
Specifications and measurements for site preparation and structural building.
Details on connecting the Fast Fill Waterfall Spout to hot and cold water valves.
Instructions for wiring the whirlpool to the power supply, including GFCI requirements.
Overview of the whirlpool's control panel and its components.
Details on how to use each button on the KeyPad A control panel.
Information on configuring and saving custom user presets for the system.
Instructions for cleaning, adjusting pressure, and removing/replacing jets.
Details on how to adjust pressure and remove/replace jets in the Shiatsu system.
How to adjust pressure, remove, and replace Pressure Plus jets.
Instructions for adjusting pressure and direction, and removing/replacing Pressure-Flo jets.
Information regarding radio frequency energy and potential interference with electronics.
Procedures for cleaning the whirlpool, air bath, and system purging.
Methods for cleaning the acrylic surface and removable jets.
Methods for removing minor and deeper scratches from the acrylic tub surface.
Information on obtaining service and warranty repairs from qualified technicians.
Information on microbes, fungi, mold, and bacteria affecting water quality.
Discussion of chemicals in water like salts, calcium, magnesium, copper, and iron.
Recommendations for treating water quality issues and using cleaning agents.
Details on covered products and specific warranty durations for components.
Steps for claims, remedies, what consumers must do, and warranty exclusions.
Covers legal rights, implied warranties, and exclusion of incidental damages.
General
