AR Blue Clean AR 142 S

Questions and Answers

C
Christopher CuevasAug 5, 2025
Why AR Blue Clean AR 142 S Pressure Washer turns on for 2 seconds then shuts off?
- Z
  Zoe CampbellAug 5, 2025
  The power washer may turn on briefly (1-2 seconds) to prime the pump when the water is connected, the accessories are properly assembled, and the power switch is on; this indicates the power washer is functioning correctly. To ensure proper operation, turn the power switch off, hold the trigger on the spray gun to allow a steady stream of water, and then, while still holding the trigger, turn the power switch back on.
K
Kimberly FrenchAug 10, 2025
What to do if I can’t remove the lance from AR Blue Clean AR 142 S Pressure Washer?
- N
  Natasha WilsonAug 11, 2025
  Insert the quick-release end of the lance/detergent bottle into the extension lance. Press the extension lance and lance together (about a 1/8”) and turn clockwise. To remove the lance, reverse this procedure. If it's still stuck, hold the extension lance and lance in an upright position with the nozzle end on the floor, push the whole assembly straight down to loosen the connection, and then try the removal process again. You can also spray soapy water or a lubricant in the area where the lance connects to the extension lance.
H
Heather BradleyAug 17, 2025
How to turn on AR Blue Clean AR 142 S?
- M
  Matthew WillisAug 17, 2025
  First, ensure the GFCI module on the power cord is plugged directly into an outlet, avoiding any extension cords. Then, with the GFCI connected, verify that the power switch is turned on.
A
Andrea HarrisonAug 22, 2025
What to do if AR Blue Clean Pressure Washer has no water flow?
- E
  Elizabeth BaileyAug 22, 2025
  If your AR Blue Clean Pressure Washer is running but not dispensing water, first check the water source. If the source is fine, try unclogging the nozzle on the lance. Alternatively, remove the lance and spray directly from the spray gun to see if that resolves the issue.
X
xleeAug 28, 2025
Why is my AR Blue Clean Pressure Washer leaking at the hose connection?
- J
  John CastilloAug 28, 2025
  If water is leaking where the high-pressure hose connects to the spray gun of your AR Blue Clean Pressure Washer, check for an o-ring at the end of the metal tip of the high-pressure hose. If the o-ring is missing, this will cause a leak.