ARAG 520005 - Starting and Operating; Topping up Liquid; Foaming Agents

11
6.5 Starting and operating
Fi g. 13
6.6 Topping up liquid
•Depressurize the tank as indicated in par. 6.1 - Discharging remaining pressure.
•Rell with liquid, observing the procedures described in the par. 6.4 - Preparing foaming
solution.
•Use only ARAG foaming agents.
•IN CASE OF DAMAGES TO THE FOAM MARKER CAUSED BY NON AUTHORIZED
FOAMING AGENTS, ALL WARRANTY CLAUSES WILL BECOME NULL AND VOID.
6.6.1 Foaming agents
CODE CONTENT PACKAGES
520050 5 lt / 1.32 US gal. tank
520035 25 lt / 6.6 US gal. tank
520033 200 Kg / 441 lb barrel
•Operate the selector lever (A, Fig. 12) onto the control box and
start the compressor.
•The indicator turns on and the circuit reaches the operating
pressure after a few seconds causing the foam to come out
from the selected foam maker.
•Adjust the intensity of the foam outlet, using the ow-rate
regulator on the tank cap (Fig. 13).
•During use it is possible to alternate the right- or left-hand
foam nozzle by moving the selector lever.
•To interrupt foam marker operation, set the switch to its central
position (OFF).