18-11-2022 Page 13 of 51 ARB Copyright 2022 37801205
If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
3.4) The foam sealing block is to be
an interference fit with the
underside of the side tub rail
and fit firmly in place as shown.
Position the top edge of the
foam block to avoid covering
weld nuts in the tub.
3.5) Use neutral cure non-acetic
silicon to fill gaps and seal
edges all around foam block
and tub.
3.6) Silicon seal all around foam
block as per picture.
Repeat steps 3.1 to 3.6 for
sealing the tub using the
right-hand tub corner sealing
foam block.
To Next Page
Loading...
