If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
3.7) On the right-hand side locate
the electrical connector (if fitted
on Wildtrack models only for
roll top tonneau covers).
Remove the clipping strap from
the tub. Wrap the end of
connector with electrical tape to
seal it off on the open
connection side and push the
connector back through the
open cavity hole and into the
void of the front corner pillar.
To Next Page
Loading...
