If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
4.2) Use 1 roll of clear 30mm wide tape
(665037) per side and cover the first 6
rectangular holes from the front along the
outside edge of the side tub rails.
4.3) Cut the tape after 6
th
hole is covered and
retain what is left on each roll for later
use.
4.4) Use firm pressure (or a roller) to apply
the tape ensuring it seals to protect
against water entry around each of
the rectangular holes.
Do both sides of the top tub rails.
To Next Page
Loading...
