If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
4.7) Spray the tub with a water film. Apply
clear neutral cure silicon to fill the gap
under the front corner of the front tub
rail and front corner holes on both
sides to obtain a water seal
4.8) Use clear neutral cure silicon to fill
the gap between the tubs’ front rail
and side tub rails.
Make smooth and neat, wipe off any
excess and allow it 10mins to skin
cure.
Do both sides of the tub.
!! IMPORTANT !!
The above steps are imperative to
ensure the tub is water sealed in the
front tub corners.
4.9) Take front tub corner mounting brackets
(668PD167R/L) and place two bumpon
clear circular pads (665076) to the tags
on the brackets as shown.
To Next Page
Loading...
