18-11-2022 Page 21 of 51 ARB Copyright 2022 37801205
If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
4.17) Use an alcohol wipe (6602018) to clean
away rust inhibitor residue.
4.18) Cut a pair of rubber tub bridge seals
(668PM005) down to 35mm width as
shown.
4.19) Apply neutral cure silicon to the ends of
the front mount rail bracket both sides, to
fill the gaps between the bracket and the
side tub rails.
Clean surrounding surfaces well using an
alcohol wipe (66020018) to remove
silicon from surrounding surfaces at the
join.
To Next Page
Loading...
