18-11-2022 Page 34 of 51 ARB Copyright 2022 37801205
If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
5.21) Locate the vehicle’s bracket
under LH lip of the front fender.
This will be used to tie off the
relay box to.
5.22) Loop a cable tie through hole in
one end of the rely box.
5.23) Locate bracket under the LH
front fender. Cable tie the relay
box to the bracket and to the
vehicle’s wiring harness.
5.24) Tie up any excess cable length
in the rear corner of the engine
bay behind the fuse box and
secure it with a cable tie to the
vehicle’s loom.
To Next Page
Loading...
