18-11-2022 Page 41 of 51 ARB Copyright 2022 37801205
If you have any queries regarding the installation of this product, please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
6.21) Behind the tailgate sealing bracket,
between the base rail and the tub rail
rear area, use neutral cure clear
silicon to fill cavity at this point and
also where the foam seal contacts
the plastic corner piece.
6.22) Clean off excess silicon and make neat.
Do both sides.
6.23) Use clear neutral cure silicon to close
the gap between top of foam tailgate
seal and plastic corner pieces
mouldings of the canopy. Also run
silicon down between the vertical
corner edge foam seal and the tub
side wall.
See more pictures on the next page.
To Next Page
Loading...
