8
3) Blade Mount Bolts and Threads
The blade mount bolts should be regularly checked for
correct torque (18Nm.)(13.2 ft lb). Whenever blades
are changed, the bolt and conrod threads should
be checked to ensure they are not worn or filled with
debris. Use only genuine ARBORTECH spares and do
not lubricate bolts, threads or conrod mating surfaces.
Fig.15
CAUTION: DO NOT operate the tool with loose
blades. If blades should come loose while operating,
the blade mounts and threads can become damaged,
requiring significant repairs to the tool.
4) Blades and Teeth
With use, the blades will become dull and the cutting
performance will decrease. Occasionally, if very hard
materials are cut, or the teeth impact a hard surface at
an odd angle, teeth may become chipped or broken.
The blades can still be used, but cutting performance
will be reduced.
If “blueing” of the blade periphery occurs, the blades
are running too hot. This occurs when the blades
become worn, too much force is applied, the operator
does not use sufficient sweeping motion or the material
is too hard.
NOTE: Using sharp blades will improve the
performance and longevity of the tool.
If the supply cord of this power is necessary, this has
to be done by the manufacturer or his agent in order to
avoid a safety hazard.
7. WARRANTY AND SERVICE
For warranty repair, inspection, service and spare parts,
please contact your place of purchase, or
Contact us directly at:
ARBORTECH PTY LTD
67 WESTCHESTER ROAD, MALAGA, PERTH
WESTERN AUSTRALIA • 6090
T: +61 (0) 8 3249 1944
Fax: 08 9249 2936
www.arbortech.com.au
E: arbortech@arbortech.com.au
UK- Declaration of Conformity
Arbortech declares that the product described
in this manual under “Technical Specifications”
is manufactured in compliance with IEC62841
standardised documents and following UK regulations:
-Supply of Machinery (Safety) Regulations 2008
-Electromagnetic Compatibility Regulations 2016
-The Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic Equipment
Regulations 2012
Technical file at: Arbortech Ltd, 67 Westchester Road,
Malaga, WA 6090, Australia
__________________
Kevin Inkster
Chairman
Arbortech Pty Ltd
__________________
Sven Blicks
General Manager
Arbortech Pty Ltd
EC- Declaration of Conformity
Arbortech declares that the product described
in this manual under “Technical Specifications”
is manufactured in compliance with IEC62841
standardised documents and in conformity with
Machinery Directives: 2006/42/EC; 2014/30/EU;
2011/65/EU.
Technical file at: Arbortech PTY LTD | 67 Westchester
Road, Malaga, WA 6090
__________________
Kevin Inkster
Chairman
Arbortech Pty Ltd
__________________
Sven Blicks
General Manager
Arbortech Pty Ltd
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling. Only for EC
countries: Do not dispose of power tools into household
waste! According the European Directive 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national law, power tools that are
no longer usable must be collected separately and
disposed of in an environmentally correct manner.
To Next Page
Loading...