3 Transport, storage and packaging ARCA Regler GmbH
12 / 28 Series 8C D / 6H D11.2018 / 1.0
3 Transport, storage and packaging
3.1 Transport
WARNING
Tipping or falling load!
Danger of death and danger of damage to property due to load tipping
over or falling!
► Only suitable and approved means of transport and lifting equipment
may be used for transporting the product.
► Lifting equipment must generally be attached to the housing of the
product, not to attachments.
► Allow only instructed persons to select and attach the lifting equip-
ment.
► Do not stand under suspended loads.
Transport at a temperature lower than -40 °C or higher than +80 °C is
not permissible.
The valve may only be transported in a pressureless and rinsed-out con-
dition.
Particular attention is to be paid to dead spaces (pressure compensa-
tion, bellows, etc.) when rinsing the valve.
3.2 Storage
NOTICE
Improper storage!
There is a danger of the product and in particular the attached electronic
accessories no longer functioning if stored improperly.
► Storage at a temperature lower than -40 °C or higher than +80 °C is
not permissible.
► It must be stored in roofed-over storage places and that are weather-
proof.
To protect against contamination and to protect the sealing surfaces,
openings such as nozzles, flanges, etc. must be sealed using suitable
means. These should be removed by technical personnel at the place of
installation.
3.3 Packaging
The product is packed in a PE film inside the outer packaging (card-
board box, wooden crate, pallet, lattice box).
If the packaging, in particular the PE film, has been opened, the product
must be stored immediately in a heated room.
The product must be packed in weatherproof or seaworthy packaging for
transport by ship, airplane, rail or truck.
To Next Page
Loading...
Need help?
General
